LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1197 (Rear Axle - Repair) >> 10 Final Drive >> 00 11 259 Oil Change In Rear Differential Including Used Oil Disposal

00 11 259 Oil Change In Rear Differential Including Used Oil Disposal

WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:

Risk of damage!

To avoid serious damage to the rear differential, it is essential to use only approved transmission oils in the differential.

NOTE:

The oil does not  need to be changed in rear differentials carrying the "Life-Time-Oil" sticker.

Only change oil when rear differential is at normal operating temperature.

Recycling: 

Catch and dispose of emerging differential oil.

Observe country-specific waste-disposal regulations

Oil drain plug present: 

Place oil collecting apparatus underneath.

Remove oil drain plug (1).

Drain and dispose of differential oil.

Undo oil filler plug (2).

Add differential oil up to lower edge of opening for oil filler plug (2); if necessary, refer to FINAL DRIVE for necessary fill quantity.

Fig 1: Identifying Oil Drain Plug
G04749230Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

  1. Oil drain or oil filler plug with sealing ring:

    Replace sealing ring (1).

    Tightening torque: 33 11 3AZ  . See REAR DIFFERENTIAL CASE WITH COVER for specs.

  2. Oil drain or oil filler plug with O-ring:

    Replace oil drain or oil filler plug (2).

    Tightening torque: 33 11 9AZ  . See REAR DIFFERENTIAL CASE WITH COVER for specs.

    Fig 2: Identifying Oil Filler Plug With Sealing Ring
    G04749229Courtesy of BMW OF NORTH AMERICA, INC.

No oil drain plug: 

Undo oil filler plug (1).

Drain and dispose of differential oil.

Add differential oil up to lower edge of opening for oil filler plug (1); if necessary, refer to FINAL DRIVE for necessary fill quantity.

Fig 3: Identifying Oil Filler Plug
G04749232Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

  1. Oil filler plug with sealing ring:

    Replace sealing ring (1).

    Tightening torque: 33 11 3AZ  . See REAR DIFFERENTIAL CASE WITH COVER for specs.

  2. Oil filler plug with O-ring:

    Replace oil filler plug (2).

    Tightening torque: 33 11 9AZ  . See REAR DIFFERENTIAL CASE WITH COVER for specs.

    Fig 4: Identifying Oil Filler Plug With Sealing Ring
    G04749229Courtesy of BMW OF NORTH AMERICA, INC.