32 41 250 Removing And Installing/Replacing Fluid Reservoir For Power Steering
WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal off pipe connections with plugs.
Necessary preliminary tasks:
- Draw off and dispose of hydraulic fluid from fluid reservoir
- M54, N52, N53, N54: Remove intake filter housing
Release screw (1).
Tightening torque: 32 41 9AZ . See PUMP AND OIL SUPPLY for specs.
NOTE:
If necessary, raise and/or turn fluid reservoir in order to gain better access to hose clamps.
Remove hose clamps if necessary with special tool 32 1 260 .
Disconnect suction and cooler return lines from fluid reservoir, check and if necessary replace.
Lift out fluid reservoir.
After installation:
- Fill and bleed HYDRAULIC SYSTEM
- Check pipe connections for leaks