51 47 491 Removing And Installing/Replacing Rear Underbody Protection

WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT UNDERBODY PROTECTION .

Not M5

Unfasten screws (1 ... 3).

Press heat shield (5) back.

Release screws (4) and remove underbody protection (6).

Installation:

Ensure correct seating.

Center underbody protection (6) and tighten down all screws.

Fig 1: Identifying Heat Shield, Underbody Protection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

M5 only

Unfasten screws (1 and 2).

Remove underbody protection (3).

Installation:

Ensure correct seating.

Center underbody protection (3) and tighten down all screws.

Fig 2: Identifying Underbody Protection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.