31 60... Press Right Output Shaft Approx. 6 To 7 Cm Out Of Front Differential
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW 535xi, 2010 BMW 528xi, 2009 BMW 535xi, 2009 BMW 528xi, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 31 5 110
Necessary preliminary tasks:
- Remove tie rod end from swivel bearing
- Remove tension strut from guide joint
- Remove control arm from swivel bearing
Press output shaft with special tool 31 5 110 out of front differential.
Insert spacer between bearing block and output shaft and secure with adhesive tape.
Installation:
Push output shaft over resistance of snap ring. Output shaft must snap audibly into place.
IMPORTANT:
High installation forces indicate that the spline teeth on the output shaft/rear differential side gear are damaged/deformed!
Check spline teeth, replaced damaged parts.
Check spline teeth, replaced damaged parts.