31 33 001 Replacing Front Left Or Right Spring Strut Support Bearing (AWD)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW 535xi, 2010 BMW 528xi, 2009 BMW 535xi, 2009 BMW 528xi, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
Installation note:
- All screws, nuts, bolts and hose clamps removed during the repair must be replaced.
- Retaining elements on chassis and suspension and steering parts must be replaced.
NOTE:
Procedure is described in replacing front left or right spring strut .
Replacement: Vehicle with spacer ring:
NOTE:
Spacer ring (A) is fitted in vehicles with "rough road package" version.
Unscrew nuts. Tightening torque 31 31 1AZ . Remove spacer ring (A) from support bearing.
Installation note: Align spacer ring (A) using centering pin (1) to support bearing and place in position. Replace self-locking nuts.
If necessary, twist/drive out centering pin (1).
NOTE:
If a support bearing (2) was fitted without centering pin (1), the centering pin (1) of the new support bearing (2) must be driven or twisted out.
After installation: If a support bearing is installed without a centering pin, perform a wheel alignment. If a support bearing is installed without a centering pin, perform a wheel alignment.