31 12 003 Removing And Installing / Replacing Top Right Wishbone

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW 535xi, 2010 BMW 528xi, 2009 BMW 535xi, 2009 BMW 528xi, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Control arms with + or - marking (see illustration) are camber correction arms:

- Under dimension variant
+ Over dimension variant

These camber correction arms are used to correct the camber values by 30 minutes. To be used only if the tolerance values are exceeded or undershot! An unmarked control arm is a standard part.

Fig 1: Identifying Control Arms

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary tasks: Remove control unit box

Important! The spring strut/lower wishbone screw connection does not have to be released!

Further procedure is identical to: Removing and installing/replacing top left control arm .