52 24 311 Removing And Installing/Replacing Lock For Left Or Right Rear Seat Backrest

WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Perform emergency actuation for rear seat backrest (1).

Unfasten screws (2).

Tightening torque: see 2AZ in 52 24 REAR SEAT (NORMAL), MANUAL .

Fig 1: Identifying Rear Seat Backrest And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove backrest and set down forwards.

Remove lock (1) completely from installation opening.

Fig 2: Removing Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Display bridge (1) can be pressed out of lock during emergency actuation.

Remove display bridge (1) from lock.

Display bridge (1) does not have to be reinstalled.

Fig 3: Identifying Display Bridge

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slide guide lug (1) of lock into opening (2).

Fig 4: Sliding Guide Lug

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting lock:

Slacken screws
Firmly push engaged backrest back
Tighten down screws

IMPORTANT:

Check backrest lock without fail.