34 52 550 Removing And Installing/Replacing DSC Sensor (S85)

WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection)! See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Necessary preliminary tasks:

Remove right front seat. See SEATS .
Remove front inside entrance cover strip. See 51 47 000 REMOVING AND INSTALLING/REPLACING FRONT (INSIDE) LEFT OR RIGHT ENTRANCE COVER STRIP .

Lift carpet (1) and fold to side.

Release screws (2) and swing out DSC sensor (3).

Installation: Tightening torque 34 51 3AZ .

Fig 1: Identifying Carpet And DSC Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connection (1) and remove DSC sensor (2).

Installation:

Make sure plug connection locks correctly.

Fig 2: Identifying Plug Connection And DSC Sensor

Courtesy of BMW OF NORTH AMERICA, INC.