34 52 535 Replacing A Rear Pulse Generator

WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection). See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Necessary preliminary tasks:

Remove rear wheel.
Read and comply with General Information .

Observe safety instructions on raising the vehicle. See 00...... LIFTING VEHICLE WITH A LIFTING PLATFORM .

Open plug housing (1).

Pull plug connection (2) out of mounting and disconnect.

Pull cable out of brackets on swinging arm.

Installation:

Ensure proper locking of the plug connector and proper seating of the cable in the brackets.

Fig 1: Pulling Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Release hexagon socket head cap screw (1) and pull wheel speed sensor out of bore.

Installation:

Tighten to specified torque. See 34 51 6AZ.

Clean bore hole for pulse generator and grease with Staburags NBU 12/K lubricating grease.

Fig 2: Releasing Hexagon Socket Head Cap Screw

Courtesy of BMW OF NORTH AMERICA, INC.