34 32 861 Replacing All Brake Pipes
WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 34 5 100
NOTE:
The brake lines are only supplied in the straight version and correct length with connecting nipple.
Read and comply with General Information .
After completing work, bleed brake system .
Read and comply with General Information .
After completing work, bleed brake system .
Observe safety instructions on raising the vehicle. See 00...... LIFTING VEHICLE WITH A LIFTING PLATFORM .
New brake lines are bent into shape with bending tool 34 5 100. Removed brake pipes can be used as templates for bending.
IMPORTANT:
- Protective coating of brake line must not be damaged during bending.
- Do not kink or bend back brake lines.
- Watch distances to rigid and movable vehicle parts. Brake lines may not make contact or rub.
- Tighten down brake line couplings with torque wrench.
Installation:
Tighten to specified torque. See Brake Lines .