33 55 021 Replacing Both Rubber Mounts For Stabilizer Mounting
WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
E61: If necessary, remove vibration damper from right retaining bracket of stabilizer.
Tightening torque, see 33 55 6AZ in 33 55 STABILIZER BAR .
Release nuts (1) on both sides.
Tightening torque, see 33 55 3AZ in 33 55 STABILIZER BAR .
Turn stabilizer in downwards direction.
Remove retaining bracket (2) on both sides.
Remove rubber mount (3) on both sides.
Installation:
Keep retaining bracket (2), rubber mount (3) and stabilizer if necessary clean and free from oil and grease.
Version with Dynamic Drive: Keep contact face for rubber mount on anti-friction bearing clean and free from oil and grease.