33 11 151 Replacing Shaft Seal For Drive Flange Left Or Right

WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 5 010
00 5 500
32 1 060
33 1 308
33 3 400
33 4 240
33 4 250
33 5 030

Necessary preliminary tasks:

Remove drive flange from rear differential
If necessary, press off dust cover

Withdraw shaft seal with special tools 00 5 010 and 32 1 060/33 1 308.

Fig 1: Removing Shaft Seal With Special Tools 00 5 010 And 32 1 060/33 1 308

Courtesy of BMW OF NORTH AMERICA, INC.

Coat housing plate flange and sealing lips of new shaft seal with approved rear differential oil. See REAR AXLE - OPERATING FLUIDS .

Drive in new shaft seal as far as it will go with following special tool(s) (depending on rear differential/outside diameter).

00 5 500 + 33 3 400: 168K/L - 78x44x10

00 5 500 + 33 4 240: 188K/L/LW - 90x44x10

00 5 500 + 33 4 250: 215K/L/LW, 220K to 230K - 100x50x10

33 5 030: 210, 215 with lock - 76x50x10

Fig 2: Installing Shaft Seal Using Special Tool

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Correct gearbox oil level/change differential oil. See REAR AXLE - OPERATING FLUIDS .