51 71 482 Removing And Installing / Replacing Left Or Right Tension Strut (On Rear Axle) (M5, M6)
WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe safety instructions for raising the vehicle
Do not drive vehicle without tension strut installed; failure to comply with this instruction will result in damage to the body!
Do not drive vehicle without tension strut installed; failure to comply with this instruction will result in damage to the body!
Release screws (1 and 2).
Remove tension strut (3).
Installation:
Replace screws.
Tighten to specified torque. See 51 61 3AZ in 51 61 REINFORCEMENT, BODY .