33 33 001 Replacing Left Or Right Rear Axle Carrier Compression Strut
WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe safety instructions for raising the vehicle.
Driving without tension and compression struts is not permitted!
Risk of damage!
The rear axle carrier must be supported at the front if both compression struts have to be replaced!
Driving without tension and compression struts is not permitted!
Risk of damage!
The rear axle carrier must be supported at the front if both compression struts have to be replaced!
Necessary preliminary tasks:
- If necessary, remove rear tension strut. See 51 71 482 REMOVING AND INSTALLING / REPLACING LEFT OR RIGHT TENSION STRUT (ON REAR AXLE) (M5, M6) .
- Remove tank cover.
- Version with Dynamic Drive: Disconnect pressure lines for oscillating motor of rear axle from tension strut.
Release screws (2). Tightening torque, see 33 32 17AZ in 33 32 CONTROL ARMS AND STRUTS .
Release bolt (1) and remove compression strut.
Secure rear axle carrier by inserting bolt (1).
Installation:
Check threads for damage; if necessary, repair with Heli-coil thread inserts.
Tighten to specified torque. See 33 33 3AZ in REAR AXLE -- TORQUE SPECIFICATIONS .