32 32 050 Removing and installing/replacing lock cylinder for steering lock (up to 09/2005)
WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Disconnect BATTERY NEGATIVE LEAD
- Remove UPPER , LOWER , and FRONT steering column trims.
- Remove RING ANTENNA
Insert ignition key into lock cylinder in such a way that release opening (arrow) remains accessible.
Turn ignition key to "R" position.
Insert special tool 32 3 110 (release tool) into release opening (arrow) until end cap (1) is released.
Slide end cap (1) to ignition key and remove with special tool 32 3 110.
Pull out lock cylinder with end cap (1) and ignition key, turn ignition key forward and back if necessary.
Installation:
Insert lock cylinder with end cap (1) and ignition key into steering column.
Align end cap (1) by way of opening to steering column and press into place.
Turn ignition key to "zero" position and remove.