32 13 650 Removing and installing/replacing EH converter for Servotronic
WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Necessary preliminary tasks:
- Remove REINFORCEMENT PLATE
- If necessary, remove heat shield.
Disconnect plug connection (1).
Unfasten screws (2).
Remove EH converter (3).
Installation:
Clean side return orifice with compressed air.
Align EH converter (3) to opening in power steering gear, press by hand into power steering gear up to stop, insert screws (2) and tighten down.
Tightening torque: see 12AZ in 32 13 POWER STEERING GEAR
After installation:
- Fill and bleed HYDRAULIC SYSTEM
Version with Dynamic Drive:
- If necessary, carry out initial Dynamic Drive operation