32 41... Instructions for removing and installing ear clips

WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The work steps are show on assorted components.
Ear clip must always be replaced.

To remove an ear clip, place special tool 32 1 260 (hose clamp pliers) at right angles to ear and cut ear open.

Fig 1: Identifying Special Tool (32 1 260)

G04726374

Courtesy of BMW OF NORTH AMERICA, INC.

The ear clip can be fitted not only axially but also radially after the hook fastener has been opened.

Fig 2: Identifying Ear Clip

G04726375

Courtesy of BMW OF NORTH AMERICA, INC.

Attach hook fastener and press ear together with special tool 32 1 260.

Fig 3: Identifying Special Tool (32 1 260)

G04726376

Courtesy of BMW OF NORTH AMERICA, INC.

Side cutter of special tool 32 1 260 can be used in areas which are difficult to access.

Fig 4: Identifying Special Tool (32 1 260)

G04726377

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Gap (A) max. 1 mm!

Fig 5: Identifying Gap (A)

G04726378

Courtesy of BMW OF NORTH AMERICA, INC.