31 35 021 Replacing Rubber Mounts Of Stabilizer Retaining Fixture On Front Axle Carrier

WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove stabilizer from front axle carrier

Remove retaining bracket (1), if necessary retaining plate (3) and rubber mount (2) on both sides.

Installation:

Keep retaining bracket (1), rubber mount (2) and stabilizer clean and free from oil and grease.

Version with Dynamic Drive: Keep contact face for rubber mount on anti-friction bearing clean and free from oil and grease.

Fig 1: Identifying Retaining Plate Bracket And Nut

Courtesy of BMW OF NORTH AMERICA, INC.