26 11 090 Removing And Installing /Replacing Centering Mount For Propeller Shaft

WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 5 500
11 1 310
11 2 030

Necessary preliminary tasks:

REMOVE PROPELLER SHAFT .

Fill centering bore (1) completely with viscous grease.

Drive special tool 11 1 310 with a plastic hammer into centering bore.

The centering mount (1) is forced out of the propeller shaft by the pressure on the grease filling.

If necessary, top up grease repeatedly.

NOTE:

To drive out the mount, you can also fill the centering bore with water instead of grease.

Fig 1: Identifying Special Tool (11 1 310)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Remove grease/water from mount bore.

Drive in centering (1) with special tools 11 2 030 and 00 5 500 into propeller shaft (observe protrusion).

Grease centering mount.

May be lubricated with any high temperature resistant, long-term grease (available locally).

Fig 2: Identifying Special Tool (11 1 310) And (00 5 500)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Observe protrusion A = 4⁺² mm of centering (1).

Fig 3: Identifying Protrusion

Courtesy of BMW OF NORTH AMERICA, INC.