23 42 581 Replacing temperature sensor (GS7S47BG SMG)
WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Before working on hydraulic system:
- Reduce pressure in hydraulic system by means of Service Functions in DIS Tester (Replacement and Repair)
- Disconnect HYDRAULIC PUMP RELAY in electronics box
Do not reconnect relay for entire duration of repair work
IMPORTANT:
After working on hydraulic system:
- Perform bleeding using DIS Tester, refer to Service Functions in DIS Tester (Replacement and Repair)
Necessary preliminary tasks:
- Unscrew and remove splash guard
- Remove REINFORCEMENT PLATE
Important notes on installation are described in this work step.
- Remove heat shields.
Disconnect connector (1).
Release temperature sensor (2).
Tightening torque: 15 Nm
Remove sensor.