23 00 123 Installing replacement transmission (GS7S47BG SMG)
WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
After completing work:
After completing work:
After completing work:
- Carry out adaptation using DIS Tester, refer to "Service Functions" in DIS Tester.
- Teach in clutch valve characteristic value
- Adapt SMG transmission completely
- Teach in clutch slipping point
- Check TRANSMISSION OIL LEVEL .
Use only the APPROVED TRANSMISSION OIL .
- Read out fault memory and clear entered faults.
Failure to comply with this requirement will result in serious damage to the manual transmission.
IMPORTANT:
After the running-in phase of 2000 km it is essential to carry out a TRANSMISSION OIL CHANGE .
Failure to comply with this requirement will result in serious damage to the manual transmission.
Recycling:
Catch and dispose of escaping transmission oil. Observe country-specific waste-disposal regulations.
Necessary preliminary tasks:
- DRAIN OFF transmission oil.
- Remove TRANSMISSION .
Modify following parts to new transmission:
- RELEASE BEARING AND RELEASE LEVER
- Modify cover caps.
- Ball pin and spring wire clip.