21 54 507 Replacing Clutch Position Sensor (GS7S47BG SMG)

WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, and 2007 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

After completing work:

Perform adaptation using DIS Tester, refer to Service Functions in DIS Tester (Replacement and Repair)
Read out fault memory and clear entered faults.

Failure to comply with this requirement will result in serious damage to the manual transmission.

Necessary preliminary tasks:

Remove EXHAUST SYSTEM .
Remove centre underbody protection.
Remove REINFORCEMENT PLATE .
Important notes on installation are described in this work step.

Remove heat shields (1) and (2).

Fig 1: Identifying Heat Shields

G04742160

Courtesy of BMW OF NORTH AMERICA, INC.

Remove heat shields (1) and (2).

Fig 2: Identifying Heat Shields

G04742161

Courtesy of BMW OF NORTH AMERICA, INC.

Remove PROPELLER SHAFT .

IMPORTANT:

Support transmission with hydraulic jack.

Release screws (1) and nuts (2) and remove cross-member.

Tightening torque: 22 32 3AZ/4AZ . See TRANSMISSION MOUNTS for specs.

Lower transmission.

Fig 3: Identifying Screws And Nuts

G04742162

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque: 21 52 9AZ . See CLUTCH OPERATION (HYDRAULIC) for specs.

Release cable tie (2). Remove plug and unclip wiring harness from holder.

Remove clutch position sensor.

IMPORTANT:

Only cable ties which are resistant to high temperatures (approx. 140 °C) may be used to secure the cable.

Fig 4: Identifying Screws And Cable Tie

G04742163

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

O-ring (1) must be mounted on the sensor and pushed on up to the flange.

When the sensors are replaced, the cable must be secured without tensile stress.

Even when the cable tie next to the marking is being positioned.

Fig 5: Identifying O-Ring

G04742164

Courtesy of BMW OF NORTH AMERICA, INC.