11 78 533 Replacing Right Oxygen Control Sensor (S85)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW M5, 2009 BMW M6, 2009 BMW M5, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 11 7 030
- 11 9 150
WARNING:
Scalding hazard!
Only perform these tasks after exhaust system has cooled down.
Only perform these tasks after exhaust system has cooled down.
Necessary preliminary tasks:
- Read out fault memory in Digital Motor Electronics (DME).
- Remove transmission underbody protection.
- Remove bottom right wheel arch trim.
Remove oxygen control sensor (1) with special tools 11 7 030 and 11 9 150.
Installation:
When using special tools 11 7 030 and 11 9 150, 47 Nm on torque wrench scale corresponds to an actual tightening torque of 50 Nm.
If the oxygen control sensor is reused, apply a thin and even coat of Never Seez Compound to the thread only.
The part of the oxygen control sensor which projects into the exhaust system branch (sensor ceramic) must not be cleaned or come into contact with lubricant.
Check function of DME.