Checking fluid level

WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

Check fluid level with engine switched off at expansion tank of power steering/ride-height control system. The fluid temperature should be approx. 20 °C here.

Ensure that the cap is fully screwed in prior to the fill level check.

If necessary, add hydraulic fluid (refer to OPERATING FLUIDS - STEERING ) up to Max. marking (1).

IMPORTANT: If the fluid level has dropped to the Min. marking (2). you must check the power steering and ride-height control for leaks and issue a separate invoice for this work.
It is not enough merely to top up the fluid.

Fig 1: Identifying Fluid Level Marks

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: To avoid mix-ups when filling with hydraulic fluid, mark the fluid reservoirs or their caps with identification marks.
ATF Automatic transmission fluid
CHF Pentosin CHF 11S

Fig 2: Identifying Fluid Reservoir Caps

Courtesy of BMW OF NORTH AMERICA, INC.