12 14 651 Replacing Suction Pressure Sensor On Charge-Air Duct (N54)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 BMW 335xi, 2010 BMW 335i, 2009 BMW 335xi, 2009 BMW 335i, and 2008 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Read out fault memory of DME control unit
Switch off ignition

NOTE: The installation location of the suction pressure sensor is at the rear end of the charge-air duct.

Preparatory tasks:

Remove suction filter housing.

Unlock plug (1) and remove.

Release screws and pull suction pressure sensor (2) out of charge-air duct.

Tightening torque 13 62 2AZ. See FUEL SYSTEM -- TIGHTENING TORQUE -- TWIN TURBO .

Fig 1: Identifying Pressure Sensor

G04755104

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check sealing ring for damage, replace if necessary.

When installing, coat sealing ring with suitable antiseize agent.

Fig 2: Locating Sealing Ring

G04755103

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE:

Check stored fault messages.

Now clear the fault memory.