12 14 521 Replacing Crankshaft Pulse Generator (N54)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 BMW 335xi, 2010 BMW 335i, 2009 BMW 335xi, 2009 BMW 335i, and 2008 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD protection).
IMPORTANT:
Aluminum screws/bolts must be replaced each time they are released .
The end faces of aluminum screws/bolts are painted blue for the purposes of reliable identification.
Jointing torque and angle of rotation must be observed without fail (risk of damage) .
Necessary preliminary tasks:
- Read out fault memory of DME control unit
- Switch off ignition
NOTE:
Installation location of pulse generator for crankshaft is underneath starter motor.
Preparatory tasks:
- Remove intake air manifold
Detach plug (1) from crankshaft pulse generator (2). Release screw.
Installation:
Replace aluminum screws.
Tightening torque 12 14 2AZ, see ENGINE ELECTRICAL SYSTEM -- TORQUE SPECIFICATIONS -- TWIN TURBO .
Withdraw pulse generator (2) from crankcase.
Installation:
Replace sealing ring.
NOTE:
Check stored fault messages.
Now clear the fault memory.