LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 650i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 111 (Air Bag Restraint Systems) >> Removal & Installation >> A-Pillar Sensor >> Removal & Installation (Left)

Removal & Installation (Left)

WARNING: This page is about a different car, the 2003 BMW 760Li, 2003 BMW 745i, and 2003 BMW 745Li. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS  . Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Remove 3 screws, lower pedal assembly trim panel, disconnect footwell light and remove trim panel. Remove front door scuff plate. Detach footrest from Velcro fasteners and remove. Remove screw and hood release handle.
  3. Remove screw and expansion rivet from upper front corner of side trim panel (cowl trim panel). Detach door weatherstrip from side trim panel. Pry side trim panel clips loose and remove side trim panel. Pull carpet slightly to one side. Disconnect A-pillar sensor harness connector. Remove screw and nuts, then remove A-pillar sensor.
  4. To install, reverse removal procedure. Ensure sensor is securely mounted. Tighten screw and nuts to specification. See TORQUE SPECIFICATIONS  . Replace damaged trim panel trim clips. Activate air bag system. See ACTIVATING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
scientia non olet · About LEMON Manuals