11 37 022 Removing And Installing/Replacing Servomotor For Left Eccentric Shaft (N62/N62TU)
IMPORTANT:
Follow instructions issued by diagnosis tester.
Risk of damage to intermediate shaft.
(cylinder bank 5 to 8)
Necessary preliminary tasks:
- Connect diagnosis tester.
- Remove ACOUSTIC COVER
- Remove ignition coil cover
IMPORTANT:
Follow instructions issued by diagnosis tester.
Unlock plug (1) on servomotor (2) and disconnect.
Unfasten screws.
Rotate servomotor (2) until no longer engaged in spline teeth of eccentric shaft.
Installation:
Replace sealing ring on spacer.
Install servomotor (1) and screw in up to spacer.
Rotate servomotor (1) into correct installation position.
Install and tighten down screws.
Installation:
Read out fault memory of control unit of Digital Motor Electronics (DME).
Check stored fault messages.
Rectify faults.
Now clear the fault memory.