51 11 156 Removing and installing front bumper trim (M6)

IMPORTANT: Risk of mixing up Different screws fitted.

Raise bonnet/hood. Release screws (1) on bumper trim (2).

Fig 1: Release Screws (1) On Top Of Bumper Trim (2)

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on bumper trim (2).

Fig 2: Release Screws (1) Under Bumper Trim (2)

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The operation is described on the left side; proceed in the same way for the right side.

Release screws (1) on wheel arch trim (2).

Fig 3: Release Screws (1) On Wheel Arch Trim (2)

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: To avoid damage, unclip the bumper trim (1) in direction of travel.

Pull bumper trim (1) in direction of arrow off side guide.

Fig 4: Pull Bumper Trim (1) In Direction Of Arrow Off Side Guide

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Have a rubber plug on hand.

Pull bumper trim slightly towards front (with aid of a 2nd person). Unlock hose (1), detach and seal pump outlet (2).

Fig 5: Unlock Hose (1), Detach And Seal Pump Outlet (2)

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, disconnect plug connection (3) at cable for ultrasonic transducer. Remove bumper trim (1) towards front (with aid of a 2nd person).

Fig 6: Remove Bumper Trim (1) Towards Front

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: Tabs (1) on bumper trim (2) must not be damaged.

Fig 7: Tabs (1) On Bumper Trim (2) Must Not Be Damaged

Courtesy of BMW OF NORTH AMERICA, INC.