41 34 041 Replacing Tail Panel

Read contents of see BODY, GENERAL .

Following new body parts are required (refer to EPC):

Fig 1: Rear Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in area (1).

Mark severance cut in accordance with measurement a and cut.

Measurement a=70 mm

Installation:

Cut-out sheet metal section is reused.

Fig 2: Weld Joint Area Dimension

Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in area (1).

Open brazed joints in areas (2).

Remove tail panel.

Fig 3: Weld And Brazed Joint On Area

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Slide tail panel (1) first on right side under side panel.

Then slide upwards on left side.

Fig 4: Sliding Tail Panel

Courtesy of BMW OF NORTH AMERICA, INC.