51 71 Gaskets and loose body components
SEALS AND LOOSE BODY PARTS - TIGHTENING TORQUES SPECIFICATION
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | Front spoiler to bumper | E36 / M3 | 3 Nm | ||
| 2AZ | Rear spoiler | E34 / Touring, E36 / Z3 Coupe / M Coupe | M6 | 6 Nm | |
| E36 / M3 | M6 | 7 Nm | |||
| E53 | 3 Nm | ||||
| E83 | M6 | 10 Nm | |||
| E61 | 8 Nm | ||||
| 3AZ | Reinforcement plate to front axle support/engine carrier | E46 / without AWD, E85, E86 | Replace screws | ||
| Jointing torque | 59 Nm | ||||
| Torque angle | 90 ° | ||||
| 4AZ | Tension strut in engine compartment | E85, E86 | Nut | 41 Nm | |
| Replace screw | 56 Nm | ||||
| Torque angle | 105 ±15 ° | ||||
| E83 | M8 | 19 Nm | |||
| 5AZ | Reinforcing plate / tension strut to rear axle | E46 / Convertible, E85, E86 | M10 | Replace screws | |
| Jointing torque | 59 Nm | ||||
| Torque angle | 90 ° | ||||
| 6AZ | Stiffening plate to body | E85, E86 | M8 | 21 Nm | |
| 7AZ | Tension strut to rear axle | E46 / Convertible | M8 | 24 Nm | |
| E85, E86 | Replace nut | 24 Nm | |||
| 8AZ | Cross-member, A-pillar, to mounting | E52 | M8 | 19 Nm | |
| 9AZ | Cross-member, A-pillar, middle | E52 | M8 | 10 Nm | |
| 10AZ | Strut to cardan tunnel | E52 | M8 | 19 Nm | |
| 11AZ | Cross-member, A-pillar, bottom, to mounting | E52 | M6 | 11 Nm | |
| 12AZ | Support tube to support, steering column upper section | E65, E66, E67 | M8 | 21 Nm | |
| 13AZ | Support tube to body | E85 / E86 | M8 | 20 Nm | |
| 14AZ | Heater to support tube | E85, E86 | 4 Nm | ||
| 15AZ | Support tube to body | E60, E61, E63, E64, E83 | M8 | 21 Nm | |
| 16AZ | Take-up, cover, sill to body | E83 | M8 | 5 Nm | |
| 17AZ | Cover, partition, to body, front | E61 | 2.5 Nm | ||
| 18AZ | Retaining strip, sill trim, to side panel | E61 | 5 Nm | ||
| 19AZ | Multifunction pan to body | E60 / M5 | 3 Nm | ||
| E86 | 12 Nm | ||||
| 20AZ | Underride protection to retaining bar | E60, E61 | M8 | Replace screws | 8 Nm |
| 21AZ | Retaining bar for underride protection to frame side member | E60, E61 | M8 | Replace screws | 8 Nm |
| 22AZ | Protective mat/protective cover to body | E60 / Security | M6 | Screw | 10 Nm |