63 13 200 Removing and installing/replacing front left or right auxiliary turn signal lamp

Slide front auxiliary turn signal lamp (1) with trim strip (2) towards rear and fold out in direction of arrow from front side panel (3).

Fig 1: Sliding Front Auxiliary Turn Signal Lamp (1) With Trim Strip (2) Toward Rear

Courtesy of BMW OF NORTH AMERICA, INC.

Remove trim strip (1) from front auxiliary turn signal lamp (2).

Unfasten plug connection (3) and disconnect.

Remove front auxiliary turn signal lamp (2).

Fig 2: Removing Trim Strip (1) From Front Auxiliary Turn Signal Lamp (2)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure trim strip (1) is correctly seated on front auxiliary turn signal lamp (2).

Fixtures (3), guide (4) and tab (5) must not be damaged.

Fig 3: Identifying Fixtures (3), Guide (4) And Tab (5)

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

If necessary, change bulb .