12 41 020 Removing And Installing/Replacing Starter Motor (N62, N62TU)

Necessary preliminary tasks: 

• Switch off ignition
• Follow instructions for disconnecting and connecting battery

  Disconnect battery negative lead and cover

• Remove REINFORCEMENT PLATE
• E60/E63/64/E65/E66 only:  Remove RIGHT EXHAUST MANIFOLD

Release screw and nut.

Remove heat shield (1).

Unfasten nut.

Tightening torque 12 41 4AZ. See ENGINE ELECTRICAL SYSTEM - TIGHTENING TORQUES .

Unlock plug (1) and remove.

Release screws and pull starter motor out of transmission mounting and remove.

Tightening torque 12 41 1AZ. See ENGINE ELECTRICAL SYSTEM - TIGHTENING TORQUES .

Installation: 

Check starter pinion and ring gear for damage, replace damaged parts if necessary.