12 41 020 Removing And Installing/Replacing Starter Motor (N62)

Necessary preliminary tasks: 

• Disconnect battery ground terminal.
• Remove right exhaust manifold.

Release screws and nut on heat shield (1) (see arrows).

Remove heat shield (1).

Installation: 

Tightening torque: 12 41 6AZ. See ENGINE ELECTRICAL SYSTEM - TIGHTENING TORQUES .

Disconnect plug connection (1) term.50.

Unscrew nut (2).

Installation: 

Tightening torque 12 41 4AZ. See ENGINE ELECTRICAL SYSTEM - TIGHTENING TORQUES .

Remove starter cable (3) term.30.

Release screws on transmission (see arrows).

Installation: 

Tightening torque 12 41 1AZ. See ENGINE ELECTRICAL SYSTEM - TIGHTENING TORQUES .

Assemble vehicle.