12 14 522 Replacing Pulse Generator On Left Inlet Camshaft (N62, N62TU)

(cylinder bank 5 to 8)

Necessary preliminary tasks: 

• Read out fault memory of DME control unit; if necessary, work through test schedules
• Switch off ignition
• Remove ACOUSTIC COVER
• Remove left ignition coil cover

Release plug connector (1) and pull off.

Fig 1: Identifying Plug Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw.

Remove pulse generator (2).

Installation: 

Replace sealing ring and coat with antiseize agent.

Fig 2: Locating Pulse Generator

Courtesy of BMW OF NORTH AMERICA, INC.