51 43 201 Removing and installing/replacing panel for roof pillar at front (A-pillar), left or right

WARNING: Follow safety instructions for working on cars with airbag systems.

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Detach mucket (1) in area of panel (2).

Unclip protective cap (3) and remove.

Fig 1: Uncliping Protective Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque 51 43 2AZ . See BODY EQUIPMENT - TIGHTENING TORQUES .

Unclip panel (2) at fastening point (3).

Feed out panel (2) from instrument panel (4) and remove.

Fig 2: Uncliping Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, lever out clip (1) remaining in bore.

If necessary, replace faulty clip (1).

Make sure guide (3) of panel (2) is correctly seated in associated mounting.

Position panel (2) preinstalled with clip (1) on associated bore and clip into place.

Fig 3: Identifying Clip, Guide And Panel

Courtesy of BMW OF NORTH AMERICA, INC.