31 10 010 Removing and installing/replacing reinforcement plate
IMPORTANT:
Observe safety instructions
for raising the vehicle
Driving without reinforcement plate is not permitted!
Driving without reinforcement plate is not permitted!
Necessary preliminary tasks:
- Remove underbody protective plate . See REMOVING AND INSTALLING / REPLACING FRONT UNDERBODY PROTECTION or REMOVING AND INSTALLING/REPLACING REAR UNDERBODY PROTECTION .
Release screws (1) and remove reinforcement plate.
Installation:
Replace screws and insertion nuts.
Tightening torque 31 10 9AZ . See FRONT AXLE - TIGHTENING TORQUES .
Replacement:
If applicable, remove heat shield.