65 95... Removing and installing/replacing intercom system inside speaker (Security)

Necessary preliminary tasks:

NOTE: Intercom system speaker is installed in pedal assembly trim.

Screw on threaded ring (1) in direction of arrow, disconnect cable, remove intercom system speaker (2).

Fig 1: Identifying Threaded Ring And Intercom System Speaker

Courtesy of BMW OF NORTH AMERICA, INC.

When replacing pedal assembly trim:

Cut through insulating mat at line (1) and remove.

Fig 2: Identifying Insulating Mat Cut Line

Courtesy of BMW OF NORTH AMERICA, INC.

Drill opening (1) for intercom system speaker at marked point.

Dimension a = 140 mm

Dimension b = 100 mm

Dimension c = dia. 38 mm

Fig 3: Identifying Drill Opening For Intercom System Speaker At Marked Point

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Carry out function check of intercom system.