51 14 110 Removing and installing/replacing rear model designation
IMPORTANT:
The INSTRUCTIONS FOR NUMBER/LETTER COMBINATION CEMENTING serve as the basis for these repair instructions and must be followed without fail.
Stick on adhesive tape (1) between edge of rear lid (2) and top edge "A". Mark measurement "B" from top edge "A" to outer edge of rear lid on adhesive tape (1).
Dimensions:
ADHESIVE TAPE DIMENSIONS
| E60 | A = 18 mm | B = 40 mm |
| E61 | A = 17 mm | B = 31.5 mm |
NOTE:
Measurements C, D and E are for information purposes only, as determined by carrier film.
520 i...540 i, 550 i: C = 7 mm, D = 7 mm, E = 20 mm
545 i: C = 4 mm, D = 5 mm, E = 20 mm
520 d...535 d: C = 7 mm, D = 7 mm, E = 20 mm
525 xi...535 xi: C = 7 mm, D = 7 mm, E = 20 mm, F = 5 mm
525 xd...530 xd: C = 7 mm, D = 7 mm, E = 20 mm, F = 5 mm
520 i...540 i, 550 i: C = 7 mm, D = 7 mm, E = 20 mm
545 i: C = 4 mm, D = 5 mm, E = 20 mm
520 d...535 d: C = 7 mm, D = 7 mm, E = 20 mm
525 xi...535 xi: C = 7 mm, D = 7 mm, E = 20 mm, F = 5 mm
525 xd...530 xd: C = 7 mm, D = 7 mm, E = 20 mm, F = 5 mm
NOTE:
Measurement C is for information purposes only, as it is determined by carrier film.
C= 9 mm
Fitting dimensions: