51 45 185 Removing and installing/replacing panel for pedals

Special tools required:

00 9 317

NOTE: Move driver's seat completely towards rear.

Drive bottom trim (1) towards rear with special tool 00 9 317 and remove.

Installation:

Make sure bottom trim (1) is correctly seated at retaining points (2).

Feed bottom trim (1) correctly into trim for pedal assembly (3).

Fig 1: Identifying Bottom Trim, Pedal Assembly And Retaining Points

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Unclip trim for pedal assembly (3) at retaining points (2) in direction of arrow.

Pull back trim for pedal assembly (3).

Disconnect associated plug connections and remove trim for pedal assembly (3).

Fig 2: Identifying Screws, Pedal Assembly And Retaining Points

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Disconnecting the plug connection for the hands-free system speaker results in fault memory entries in the telephone control unit (limitation in the emergency SOS call system).
After fitting, read out fault memory and if necessary delete entries.

Replacement:

Remove SPEAKER FOR HANDS-FREE SYSTEM
Remove FOOTWELL LIGHT

Security version

Remove intercom system speaker