41 33 040 Replacing Front Wall

Read contents of BODY, GENERAL .

Following new body parts are required :

• Connection, front end/side frame
• Mounting, bumper, front middle
• Holder, side panel, bottom left
• Holder, front wall, left
• V-support
• Holder, front wall, right
• Holder, side panel, bottom right
  Fig 1: Identifying Holder, Front Wall, Right And V-Support

  Courtesy of BMW OF NORTH AMERICA, INC.

Open screws (1).

Open screws along line (1).

Remove front end/side frame connection (2).

Open screws (1) and (2).

Remove front middle bumper mounting (3) and V-support (4).

Drill out rivets (1).

Open screws (2).

Remove carrier for bumper trim with deformation element (3).

Remove front wall holder (4).

Installation: 

If necessary, use screws or locking pins (instead of rivets) to secure deformation element.