51 42... Removing and installing/replacing door pocket on rear left or right door trim panel (up to 03/2007)

Necessary preliminary tasks:

IMPORTANT: Only drill down to door trim panel area (2) so as not to damage the contact surface.

Drill out welding spots (1) on door trim panel (2) with 8 mm dia. welding spot drill bit and remove door pocket.

NOTE: Door pocket is welded to door trim panel only on initial installation.

If necessary, release nuts instead of welding spots (1).

Fig 1: Identifying Welding Spots And Door Trim Panel Area

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Secure door pocket with nuts (1) to door trim panel (2).

Fig 2: Identifying Nuts And Door Trim Panel

Courtesy of BMW OF NORTH AMERICA, INC.