12 61 280 Removing and installing/replacing oil pressure sensor (N52, N52K, N51, N54, N53)
Necessary preliminary tasks:
- Switch off ignition
- N52, N52K, N51, N53 only:
- Remove IGNITION COIL COVER
- N54 only:
- Remove intake filter housing
WARNING:
Scalding hazard!
Only perform this task on an engine that has cooled down.
Only perform this task on an engine that has cooled down.
Installation location:
Oil filter housing, front left.
Engine oil may emerge when oil pressure sensor is replaced have a cleaning cloth ready.
Unlock plug (1) and remove. Release oil pressure sensor (2). Tightening torque 12 61 1AZ .
Installation:
Check engine oil level, top up engine oil if necessary.