51 24 325 Removing and installing/replacing left tension spring for rear lid

Special tools required:

Necessary preliminary tasks:

WARNING: Support rear lid in fully opened position with suitable apparatus. Risk of injury.

Attach special tool 51 3 290 in tension spring (1) and pull towards rear.

Installation:

Reattach tension spring (1) in same position.

Fig 1: Identifying Tension Spring

Courtesy of BMW OF NORTH AMERICA, INC.

Unhook tension spring (1) from rear lid hinge (2).

Fig 2: Unhooking Tension Spring From Rear Lid Hinge

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts on the tension spring must not be damaged or missing:

Plastic sleeve
Foam inlay in tension spring

Fig 3: Identifying Parts On Tension Spring
Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Semicircular rubber buffer (2) (from window repair kit) must be fitted to rear lid hinge (3) without end stop (1).

Stick semicircular rubber buffer (2) at spacing (A) on rear lid hinge (3).

A = 65 mm

Semicircular rubber buffer (2) must touch rear lid hinge (3) in area (4) with rear lid open.

Fig 4: Identifying Rubber Buffer And Rear Lid Hinge

Courtesy of BMW OF NORTH AMERICA, INC.