51 43 070 Removing and installing/replacing side trim panel, footwell, on A-pillar, left

Necessary preliminary tasks:

Release door mucket (1) in area of footwell side trim panel on A-pillar on left (2).

Unscrew bolt (3).

Remove engine hood actuator lever (4) from footwell side trim panel on A-pillar on left (2).

Fig 1: Removing Engine Hood Actuator Lever From Footwell Side Trim Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew bolt (1).

Unclip footwell side trim panel on A-pillar on left (3) in direction of arrow from retaining point (2) and remove.

Fig 2: Removing Footwell Side Trim Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, lever out clip (1) remaining in bore.

If necessary, replace faulty clip (1).

Place footwell side trim panel on A-pillar on left (2)

preinstalled with clip (1) on associated bore and clip into place.

Replacement:

Press catches and remove switch for unlocking rear lid (3).

Fig 3: Removing Switch For Unlocking Rear Lid

Courtesy of BMW OF NORTH AMERICA, INC.