51 47 490 Removing and installing / replacing front underbody protection

All except M5:

Release screws (1 and 2) and pull out underbody protection (3) from under bumper trim.

Installation:

Ensure that seals are correctly seated.

Center underbody protection (3) and tighten down screws (1) and (2).

Fig 1: Pulling Out Underbody Protection From Under Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

If necessary, remove catches (1) on cover (2).

Fig 2: Identifying Catches On Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Version with rough road package:

Release screws (1 and 2).

Feed out underbody protection (3) towards rear.

Installation:

Replace screws (1).

Tightening torque 51 71 20AZ . See 71 GASKETS, SEALS, LOOSE BODY PARTS .

Fig 3: Removing Underbody Protection

Courtesy of BMW OF NORTH AMERICA, INC.