Preparation Of New Part

Slide in rear trim panel (1) from bottom upwards.

Adjust in combination with tailgate and rear lights to fit and secure.

Fig 1: Sliding Rear Trim Panel

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Retaining screws must not be used in area (1)

In areas (2 to 5) set 4.2 mm dia. holes for blind rivets N3:

RIVETS REFERENCE CHART

Remove new part and deburr bore holes.

Fig 2: Identifying Rivet Areas

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Do not grind/sand new part in area of bonding surfaces.