Special tools required

• 00 9 321

Carefully release trim (1) with special tool 00 9 321 from retainers (3) and lock pins (2).

Fig 1: Removing Trim With Special Tool 00 9 321 From Retainers And Lock Pins

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Clips (Hutfix) (1) must be seated in associated mountings.

Replace clips (Hutfix) (1) if they were released during removal.

1. A Turn clip (Hutfix) (1) with screwdriver to left by approx. 90°
2. B Lever out clip (Hutfix) (1) from below
   Fig 2: Turning Clip (Hutfix) With Screwdriver To Left By Approx 90°

   Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Lock pins (1) and retainers (3) on trim (2) must not be damaged.

If necessary, replace lock pins (1) and retainers (3).

Fig 3: Identifying Pins And Retainers On Trim

Courtesy of BMW OF NORTH AMERICA, INC.