5114110 Removing and installing/replacing rear model designation (Brilliance)

Attach adhesive tape (1) between edge of rear lid (3) and top edge measurement "A".

Mark measurement "B" from outer edge of rear lid on adhesive tape (1) and stick on adhesive tape (2) vertically.

Measurements E60: 

1. A =18 mm
2. B = 38 mm

Measurements E90: 

Fig 1: Identifying Rear Model Designation Measurements

Courtesy of BMW OF NORTH AMERICA, INC.

1. A = 25 mm
2. B = 46 mm

Pull off liner (protective strip for adhesive surface).

Position characters on adhesive tapes (1 and 2) and stick into place.