The following additionally applies
Shielded lines
Contact points in the shield can cause problems with regard to noise radiation and interference immunity. Consequently, distinctions have to be drawn between the following types:
Coaxial line
- Shielded RTK031 coaxial lines may only be repaired with special crimping tools..
CVBS lines
- CVBS lines may not be repaired.
- CVBS lines must be replaced in their entirety.
HSD lines
- HSD lines may not be repaired.
- HSD lines must be replaced in their entirety.
Optical fibre cable:
NOTE:
Optical fibre cables are colored differently as follows:
- Green = MOST (M edia O riented S ystems T ransport) optical fibre
- Yellow = ISIS (I ntelligent S afety I ntegration S ystem) optical fibre
- Orange = repair optical fibre cables
IMPORTANT:
- Optical fibre cables are permitted to show only one separation point (bridge), replace optical fibre cables if necessary
- Smallest permissible bending radius is 25 mm
- Avoid influence of heat ≥ 85°
Treating CABLES AND OPTICAL FIBRE CABLES .
FlexRay:
It is possible to repair the FlexRay. In the event of damage, the cables can be joined with conventional BUTT CONNECTORS .
NOTE:
- The line is a twisted cable. If possible, maintain twist in line after repair.
Airbag lines:
See REPAIRING AIRBAG CABLES .
Ribbon cables:
See REPAIRING RIBBON CABLES .